Automatic Controller for Water Pump



Automatic Electronic Pump Controller made in Italy

This controller is used to automatically control the functioning of water pumps. With an intelligent mix of hydraulic and electronic engineering, the control maintains both pressure and flow no matter whether it's 1 tap turned on, or 4 taps.

The device controls the operation of the pump automatically without the need for a pressure tank as in the older traditional systems, or you can add a pressure tank still to take up leaks and drips, or small water use.  No adjustment or maintenance is required, giving you dependable use.

Installation is a breeze - plug your pump into the controller via a 3 pin plug receiver connected to the controller, and the controller into your power source via 3 pin power plug.  We do recommend you plug into your power source via a surge protection device as power fluctuations and spikes can blow the circuit board. 

The unit will function automatically, turning the pump on when a tap is turned on.  There are LED lights to indicate operational problems such as water failure, obstruction restricting flow etc.  Once the problem is rectified, reinstatement is simple by simply pressing the Reset button.

This product is sold pre-wired with a standard 3 pin plug for the mains and a 3 pin receiver which allows for a 3 pin plug from the pumps motor to connect directly in to the controller.

Rated Voltage: 220V-240V
Maximum Current: 10A/2HP
Frequency: 50-60HZ
Maximum Power: 1.5KW
Starting Pressure setting: 1.5 Bar
Maximum Operating Pressure: 12 Bar
Maximum Operating Temperature: 65C
Minimum Flow: 1 Litre Per minute
Connection thread: Male G1"
Protection Grade:IP65

1 Year warranty



Related Items


x