$99.00 NZD
GST included in the price

Automatic Electronic Pump Pressure Switch with built on Pressure Gauge

This controller is used to automatically control the functioning of water pumps. With an intelligent mix of hydraulic and electronic engineering, the control maintains both pressure and flow no matter whether it's 1 tap turned on, or 4 taps.

The device controls the operation of the pump automatically without the need for a pressure tank as in the older traditional systems, or you can add a pressure tank still to take up leaks and drips, or small water use.  No adjustment or maintenance is required, giving you dependable use.

Installation is a breeze - plug your pump into the controller via a 3 pin plug receiver connected to the controller, and the controller into your power source via 3 pin power plug.  We do recommend you plug into your power source via a surge protection device as power fluctuations and spikes can blow the circuit board. 

The unit will function automatically, turning the pump on when a tap is turned on.  There are LED lights to indicate operational problems such as water failure, obstruction restricting flow etc.  Once the problem is rectified, reinstatement is simple by simply pressing the Reset button.

  • Single Phase
  • Rated Current 10A
  • Connections Inlet/Outlet Male 1"
  • Special non return valve avoids surges
  • Switch will not work without water
  • Built in pressure gauge
  • Manual Start Button (RESET)
  • Pump Working LED (ON)
  • Security System LED (FAILURE)
  • Max liquid temperature 60C
  • Start Pressure 1.5Bar
  • Max operating pressure 10Bar
  • Protection Grade:IP65


1 Year warranty

NOTE: This is the pressure switch only as per the main photo.  Pump shown in photo 2 is not included